How to Fix The Dead Grinding Machine – Before repairing the hand grinding machine that suddenly dies when used, we must know the cause first. If you have discovered the source of the problem, then we make improvements to the grinding machine.
The thing that should be considered when fixing the hand grinding machine is not to after unpacking the hand grinding machine, then forgetting to squeeze it back.
Below are the causes and how to repair the grinding machines that suddenly died when worn. And the damage is usually influenced by parts of the hand grinding machine that are no longer functioning. What are the parts? Let’s take a look at the following descriptions of the causes of dead hand grinding machines and how to overcome them.
How to Fix The Dead Grinding Machine
1. Disconnect Cable
Cable on the hand grinding machine is a conduit between the hand grinding machine with a power source. If the cable disconnect, the automatic electric current can not flow and the hand grinding machine can not live. To find out if there is a cable that is broken or not, can check the cable using a multitester.
When you find a disconnected or unconnected cable, how to fix it is by reconnecting the severed cable and closing it with Isolatip.
2. Broken switch
The switch is a connecting device and an electrical breaker. While on the hand grinding machine, the switch is a safety device that aims to prevent us from being surprised at the time of turning the hand grinding machine when the cable is connected to the power source.
However, when the switch in the hand grinding machine has suffered damage, the electricity coming from the power source will not be able to reach the engine grinding machine. And finally the hand grinding machine will not be able to be turned on. How to deal with this problem is to replace the broken switch with the new switch.
3. Carbon Brush Out
The next cause of damage to hand grinding machine is carbon brush/charcoal has been exhausted. If the charcoal in the hand grinding machine has run out, automatically the electric current flowing from the power source will be stopped and will not reach the drive rotor.
And finally the hand grinding machine will not be able to be turned on. This problem is very easy to overcome, by replacing the carbon brush that has expired with a new carbon brush.
4. Burned Rotor and Stator
Burned rotors and stators can be seen from the rotor as well as the stator that have been burnt or scratched on the rotor wall and the stator. The cause of the rotor is usually due to the friction between the rotor and the stator.
Friction from both parts will result in short-circuiting, resulting in both parts being burned. This is usually due to the rotor bearings that have been damaged so that the rotor rounds will be unbalanced and touch the stator.
If the rotor and stator have been burned it is recommended to buy a new grinding machine because the cost of replacing those two parts is just a little bit with the new grinding machine.
That’s why reviews of causes and how to fix the dead grinding machine. Hopefully it can be understood and become something useful for us if experiencing problems on the hand grinding machine as mentioned above.
More Article :
- How to Fix Vibrating Hand Grinding Machine
- How to Fix the Total Die Electric Drill Machine
- How to Replacement Carbon Brush Grinding Machine
- How to Fix Hot Fast Grinding Machine
- Type and Size Carbon Brush of Grinder